100mm HD sliding rear drive shaft for all Suzuki Jimnies of any year and engine, produced in Italy by a specialized company.
This particular shaft has the closed length identical to the original shafts but has the possibility to stretch up to 5 cm more than the original, so it is ideal on trims over + 5cm or if elongated struts are installed.
These shafts are balanced at 2800 rpm and are built using high quality joints and crosses and not agricultural components like most of the products in circulation.
This particular shaft, designed to eliminate any vibration and any danger of breaking, is constructed by making the following improvements to the serial shafts:
- slide joint with grease, larger diameter than the original;
- flange capacity stretch up to 10 cm, ideal for raised structures, avoids inclusion of extensions canceling any form of vibration;
- increased u-joints and standardized sizes, and can be purchased from any spare parts dealer, equipped with grease nipple, with a working angle of 10° greater than all Original;
- flange Forged high quality which allow an inclination of cruises up to 35° enable the use with raised structures.
- pipe Increased diameter, 60mm against 50mm of original, carefully balanced to avoid any form of vibration;
- sliding joint Up to 10 cm with shrinking metal protection with o-ring protection, allows a protective slide from damage caused by stones, sand and the like and protects the slide from dirt.
