Bump stop Jeep Wrangler
Adjustable rear Bump Stops for Jeep Wrangler JK, JL and Jeep Gladiator JT*.
They are designed for specific installation on the DANA44 and DANA30 rear axle with an optimal size so as not to interfere with the springs, thanks to their modular structure they allow you to find the ideal limit switch length for the set-up and oversized tires installed on your Jeep .
The system is modular with a height of +1", +2" and +3", each thickness, built in polyester reinforced plastic material to be highly resistant to impact, is firmly fixed to the ergal base using 4 stainless steel concealed screws, this system guarantees secure fixing and quick and easy installation without the need to disassemble the springs.
If necessary, it is possible to purchase the additional kit to bring the limit switches to +4".
Considering the use of mudguards and rims with the same ET as the original, it is possible to install oversized tires as follows:
- 33" with limit switch +1"
- 35" with limit switch +2"
- 37" with limit switch +3"
In order not to penalize off-road performance, it is recommended to install a lift kit at least equal to the height of the installed limit switches.
*for Jeep JT it is necessary to make two holes for their installation.
