Pair of shock absorbers completely Made in Italy, made with internally lapped steel pipes, in addition to being painted with epoxy powders, they are previously phosphated to prevent corrosion, therefore they are protected from atmospheric agents and do not even paint during heavy use.The bushings are in polyurethane, resistant to deformation and wear, use sintered components to have maximum control over the calibration and graphite Teflon seals to improve smoothness and silence.They are calibrated in compression like the originals to promote comfort, but more braked in extension to reduce the hopping of the vehicle. This calibration is designed to best adapt to the Italian off-road vehicle and is compatible with any type of set-up, however, when ordering, the desired one can be chosen at no extra cost.They can be recalibrated and revised in all their parts. In the first year after purchase, recalibration is carried out on your request free of charge.Inside the shock absorber there is a first internal limit switch in extension resistant up to 5000kg and a second polyurethane limit switch that slows down the last 10mm of stroke to avoid excessive stress. Six supports to the frame, can be used as an excursion limit for the axle .ROTHEN oil with high viscosity index is used, which guarantees the maintenance of the calibration up to 200 ° C, therefore these Suzuki Jimny shock absorbers are also suitable for heavy use and raids in the desert. In the section dedicated to the technical info you will find the measures and the technical characteristics.