Cod. 5031
limited stock

Reinforced front axle shafts Jeep Wrangler JK Rubicon Dana 44

Add to cart

Kit of reinforced front axle shafts produced by the American company Ten Factory in 4340 Chrome-Molybdenum steel, treated with a black oxide finish against corrosion, with DANA SPICER crosses.

They are heat treated both on splines and at possible breaking points, this version is suitable for all JK RUBICON that use the front axle DANA 44 with 30 spline differential, both with original differential and with ARB block.

Ideal for those who use the Jk in demanding off-road and do not want to risk breaking the original axle shafts, recommended for tires up to 37 ".

It is not possible to install them on the other non-Rubicon versions, for the Sahara, Move and other versions that use a DANA 30 axle, this kit must be installed.

The length of the reinforced axle shafts are 50.09 cm for the left and 85.44 cm for the right.

Measurements are taken from the start of the axle shaft to the center of the spider.

This kit has a 10 year official Ten Factory warranty.



Log in to view the file